Troubleshooting - Klarstein 10030844 Bedienungsanleitung

Problem
symbol is lightening on
and the arrow flashes.
symbol is lightening
and letter "F" flashes.
Errorcode
Errorcode
Ice cubes on the evapora-
tor stick together.
There are ice-cube inside
the unit, but can't dispen-
se the ice-cube when you
push the "ICE" button.
Ice making cycle is normal
but no ice is made.

Troubleshooting

Possible Cause
Lack of Water.
There is too much ice.
No ice cube inside.
Ambient temperature
sensor breakdown
The ice-making box can
not reset normally.
The ice cycle is too long.
Water temperature in
inner tank is too low.
Moving shaft for the Ice-
cube is blocked.
Ambient temperature
or water temperature in
inner tank is too high.
Refrigerant liquid leakage. Verify by a qualified technician.
Pipe in the cooling sys-
tem is blocked.
Solution
Stop the ice maker, fill water, and press "ON/OFF"
button again to restart the unit.
Suggest you to obtain the ice-cube.
Remove the probable obstacle inside or clean the
inside wall of the ice storage, if still can't start to ice
making process, press "SELECT" for more than 5
seconds to run the ice making for 10 cycles at most.
The unit can still work, but suggest to call the ma-
nufacturer service man or electrical technician to
change to a new sensor.
Call the manufacturer service man or qualified
technician to check the problem.
Stop the ice maker, and restart it after the ice blocks
melt. Select the small size ice cube selection.
Change the water in the inner Tank. Temperature of
water is better set between 7 -32 .
Release the button for ice-cube for 3 seconds, then
again push the "ICE" button.
Please run the ice maker below 32 and pour colder
water into tank.
Verify by a qualified technician.
14