Klarstein 10030844 Bedienungsanleitung Seite 12

2. Plug your ice-maker into the main power outlet, then the
3. Press "ON/OFF" button on the control panel to begin the ice making cycle. After this, the
change to light on always in LCD display window, and
size of ice-cube is Large. If you want to select the size of the ice cube, just press the "SELECT" button to
select between Large size
add the each ice-making cycle time by "SELECT" button. During the unit ice-making running, always press
the "ON/OFF" button for more than 5 seconds, digit "0" will appear in the TIMER delay time displaying
area of LCD window, which means the standard time of the once ice-making process, continue to press the
"SELECT" button, the digit will change from 0 to 1, again 2, then return 0. After 5 seconds, the setting will
complete and the digit will disappear and be remembered by the controller. With digit 1 setting, it will add
1 minute to standard duration time of each ice-making cycle, and the digit 2 setting, the added time will be
longer more. And if the unit is plugged on again, it will recover to the digit 0 setting with standard time.
4. The ice making cycle lasts 6 to 12 minutes, depending on the size of the ice cube selection and the ambient
temperature.
5. While the ice-maker is on, verify water level periodically. If water pump can't pump out water, the ice maker
will stop automatically, and the
flash. Need to pour water into the water reservoir inside. We suggest you should press "ON/OFF" button to
turn off the unit first, then fill water up to the MAX level mark, again press "ON/OFF" button to restart the
unit. If you only fill the water in, but doesn't press any button, you will need to wait some time to desire the
ice-cube. Allow the refrigerant liquid inside the compressor at least 3 minutes to settle before restarting.
When Ice Full indicator is on
6. The ice maker automatically stops working when the ice-cube is full inside and the
LCD displaying window will be indicated.
How to obtain the ice-cube
7. Put your ice-cube container on drip tray, press the "ICE" button one time on control panel (Button B in above
illustration), the symbol will light on the LCD window, then the ice cube pushing spring start to rotate,
the ice-cube will fall down into your ice-cube container from the ice-cube tap. And press the "ICE" button
again, the symbol will disappear in the LCD window, the internal pushing spring will stop rotating and
the ice-cube will not flow out again.
How to dispense the water
8. Default time of water flowing: 10 S. Put your water cup on drip tray, press the "WATER" button once on con-
trol panel (Button C in above illustration), the water will flow out from middle water tap, and the
will light on and the "10 S" will display in the TIMER delay time displaying area of LCD window, with the
time pass, after 10 seconds, the symbol disappears and water dispensing will finish and water will not flow
out again. If the water flowing time is too short or too long, you can set it again yourself. Always press the
"WATER" button for more than 5 seconds, "10 " will appear in the TIMER delay time displaying area of LCD
window, continue to press the "SELECT" button to select the suitable time which range is from 7 seconds to
25 seconds. After 5 seconds, the setting will complete and the new digit will disappear and be remembered
by the controller. Next time, if you want to dispense the water, it will work according to the new set time..
and Small size . If you still think the ice cube size is not fit for you, you can
symbol will light on LCD displaying window and the arrow symbol will
symbol will flash in LCD display window.
symbol will flash on in the mean time. The default
symbol will
ice full" symbol on
symbol
12