Hoover Otsein VISION Bedienungsanleitung Seite 25

When using your new Hoover Vision for the first time
Your new Vision washing machine incorporates highly sophisticated Inter@ct technology
which always ensures the best performance is achieved automatically. The Vision display
panel is a good example of Inter@ct technology as you can always see in plain English what
the machine is doing both before a wash programme (when you are setting the various
programmes and options) and during a cycle (when the display lets you see the stage the
cycle has reached). In this way, the Vision panel Inter@cts with you and really does serve as
your personal Washing Advice Centre.
This machine will operate prior to programming the Vision set up. However, this machine has
Start Delay and Programme End functions and for these functions to work efficiently the
Vision set must be programmed. This is a simple operation and special care has been taken
during manufacture to ensure that the user can operate this machine simply and effectively.
A quick guide around your Vision menu:
Connect product up to the electric / water supplies and drainage (see pag. 8).
Select any wash programme. After a short time a message will be displayed:
Note: The first message appear in Spanish. See below for changing to English.
HOOVER VISION
BIENVENIDO! 11:05
1 ALGODÓN BLANCO
90° FUERTE 1600 rpm
Prior to entering the Vision pre set, remember time is limited while you decide on your options
(30 sec. / section). If you run out of time start from this point again.
Hold down at the same time the "Timer saver" (Lavado Rápido) and "Extra rinse" (Super
Aclarado) buttons for 5 sec. until screen changes to:
CAMBIAR LENGUAJE
ESPAÑOL
CHOSEN LANGUAGE
ENGLISH
Press "Timer saver". This confirm and enters an option
accurate time can be reset later
this is displayed if prog. 1 is selected
Press the "Extra rinse" button to change
the language to English.
48
SET TIME MODE TO
ABSOLUTE
Press "Timer saver"
ENABLE FINAL BLEEPING
YES
Press "Timer saver"
SET NEW TIME
hh:
Press "Timer saver"
SET NEW TIME
mm:
PPress "Timer saver"
ENABLE MEMORY ?
YES
Press "Timer saver"
SET DEMO MODE ?
NO
Press "Timer saver"
EXIT MENU?
YES
Press "Timer saver"
1 WHITE COTTON
90° HEAVY 1600 RPM
You are now able to select any wash programme. You can if you wish also set a delay start.
Where more detailed information is required refer to the relevant section from the following pages.
if RELATIVE is displayed press
"Extra rinse"
(This changes a menu option)
if NO is displayed press
"Extra rinse"
to change hours press the
"Extra rinse" until correct
to change mins press the
"Extra rinse" until correct
if NO is displayed press the
"Extra rinse"
always select NO,
if YES press "Extra rinse"
if NO is displayed press the
"Extra rinse"
reverts back to the wash programme
selected
49