Source switch:
1. Press key „source" on remote control. The screen will show source
(picture1).
2. Press „/" key to choose the mode.
3. Press „" or „OK" key to confirm.
When using the projector first time, it will commonly appeared with image faintness and the image is
trapezoid. Following suggestions below to adjust focus.
Focus adjustment
Turn the lens into the projector (1), then turn it out slowly (2), at the same time looking at the resolution
point care when the image is very clearly (take the middle area of the image), it is the best situation of the
lens.
Remote control instruction
Image adjustment
(1)
(2)