Image Adjustment - Chal-Tec electronic-star 10005060 Anschluss- Und Anwendungshinweise

If the projector is the new one. Please read "projector install" chapter. Placed the projector. Connect the
powerwire and the signelwire. The operation as follow:
Open operation
1. Before use the remoter. Put in two 7 size battery in it.
2. Open the power switch on the backboard. The power
light begin to flash.
3. Press the power key on the remote control or panel.
The indicator light turn light.
4. Alter 2 second. the projector lamp begin work. began appear unclear white light on the screen.
After 2 minute projector begin work ..
5. For the new projector. When the frist time to use. maybe will appear image unclear or trapezoid
distortion . please rend "image adjustment" chapter.
6. After the image is clear. then you can watch program. during watching. you also can setup the
system parameter. please read "menu setting" chapter»
Close operation
1. During use the projector. press "power" key. can let the projector switch to situation.
2. After inter into stay situation. the projector under auto protect, auto release hot. the indicator light
is flase situation. but here. the projector is under auto protect situation. not accept any order. if
need to startup again . must wait for finished the release hot .
When you use the projector first time. It normally will appear image faintness or the image is trapezoid. It is
the reason of lens focus or trapezoid correction. Please follow the step the correction:
Focus correction
Turn the lens into the projector (1), then turn it out slowly (2), at the same time looking at the resolution
point care when the image is very clearly (take the middle area of the image), it is the best situation of the
lens.
Note: When you replace the projector from a cold to a warm environment water vapour might occur. Don't
turn the projector on when this occurs but wait until the vapour has disappeared.
Keystone correction
If a projected picture has keystone distortion, correct image with Keystone adjustment. The image becomes
trapezoid shape when the screen or project is not level. Please reposition the projector to improve its angle
to the screen. However, the circumference of the image may not be focused.
If not able to use K. correction function to correct the trapezoid distortion. Please reduce of the projector to centre the screen vertically.
Open/close

Image Adjustment