Ryobi OBL18JB Übersetzung Der Original-Anleitung Seite 5

■
Do not point the blower nozzle in the
direction of people or pets.
■
Never place objects inside the blower
tubes.
■
Do not place the product on top of or near
loose debris. Debris can be sucked into the
intake vent, resulting in possible damage
to the product.
ADDITIONAL BATTERY SAFETY
WARNINGS
WARNING
To reduce the risk of fi re, personal injury,
and product damage due to a short circuit,
never immerse your tool, battery pack, or
charger in fl uid or allow a fl uid to fl ow inside
them. Corrosive or conductive fl uids, such
as seawater, certain industrial chemicals,
and bleach or bleach-containing products,
etc., can cause a short circuit.
TRANSPORTATION AND STORAGE
■
Stop the product, remove the battery pack,
and allow it to cool down before storing or
transporting.
■
Clean all foreign materials from the product.
Store the product in a cool, dry, and well-
ventilated place that is inaccessible to
children. Keep away from corrosive agents,
such as garden chemicals and de-icing
salts. Do not store outdoors.
■
For transportation in a vehicle, secure the
product against movement or falling to
prevent injury to persons or damage to the
product.
TRANSPORTING LITHIUM BATTERIES
Transport the battery pack in accordance with
local and national provisions and regulations.
Follow all special requirements on packaging
and labelling when transporting batteries by a
third party. Ensure that no batteries can come
in contact with other batteries or conductive
materials while in transport by protecting
exposed connectors with insulating, non-
conductive caps or tape. Do not transport
battery packs that are cracked or leaking.
Check with the forwarding company for further
advice.
MAINTENANCE
WARNING
Use only original
replacement parts,
attachments. Failure to do so can cause
possible injury and poor performance, and
may void your warranty.
WARNING
Servicing requires
knowledge and should be performed only by
a qualifi ed service technician. For service,
bring the product to an authorised service
centre. When servicing, use only original
replacement parts.
■
Do not make adjustments and repairs not
described in this manual. For other repairs,
contact an authorised service centre.
■
After each use, clean the product with a
soft, dry cloth.
■
Check all nuts, bolts, and screws at
frequent intervals for proper tightness to
ensure that the product is in safe working
condition. Any part that is damaged should
be properly repaired or replaced by an
authorised service centre.
■
Bring the product to an authorised service
centre to replace damaged or unreadable
labels.
CLEARING A BLOCKAGE
■
To reduce the risk of injury associated
with contacting rotating parts, always stop
the product, remove the battery pack, and
make sure all moving parts have come to a
complete stop.
■
Remove the blower tubes to inspect for
blockage. Clear the tubes if required.
■
Re-install the blower tubes before starting
the product.
RESIDUAL RISKS
Even when the product is used as prescribed,
it is still impossible to completely eliminate
certain residual risk factors. The following
hazards may arise in use, and the operator
should pay special attention to avoid the
following:
manufacturer's
accessories, and
extreme care and
3