General Information - CBE CB 510 Gebrauchsanweisungen

GB
The CB 510/516 switch-mode battery charger has been expressly designed for the caravanning and
boating sector and can automatically charge 12Vd.c. lead batteries.
The battery charger is protected against overtemperature and the 12Vd.c. outputs are protected against
short circuit and polarity inversion.
The charging system is carried out in 4 stages:
1)
battery charging
Note: the end-charge voltage is reached only if the battery is efficient.
2) when the
end-charge
batteries) or 8 hours (gel batteries) with constant voltage.
3) voltage holding 13.8Vd.c.(gel batteries) or 13.5Vd.c. (lead batteries)
Constant
4) After 10 hours, the battery charger reaches the
when the battery voltage is lower than 13Vd.c.
The high frequency switching technology allows to have high performances with small dimensions and
limited weight.
CONNECTIONS
1
BLACK 12Vd.c. BATTERY
1)
2)

GENERAL INFORMATION

with maximum current until the end-charge voltage is reached:
threshold is reached the charger continues to operate for 90 minutes (lead
Battery
Pb / Gel
15A
CB 510
F1
25A
CB 516
1
- 12Vd.c. supply (BLACK)
+ 12Vd.c. supply (BLEU)
- Technical data are indicated also in the label inside the cover -
mode and begins to operate again only
stand-by
230Va.c. On/Off
2
2
BLACK
5
Fuse 230Va.c.
F2 - F 2A
SIGNAL
1) Output +12Vd.c. (S) power
supply signal
(To connect to CBE equipment)
2) N.C.