Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Attention – Damage to device!
Under no circumstances may the fan cover on the rear side of the device be closed.
This would interrupt the supply of cooling medium required in operation.
Never touch the piezo crystal at the front of the device with sharp-edged objects. This
component may be damaged by improper handling.
Protect the plasma generator from falls or other hard impacts which may damage the
electronics or piezo crystal.
1.2
Information and obligations for the operator
•
The system may emit interference.
-
The system has been tested in accordance with EMC legislation.
-
The operator must verify and assure electromagnetic compatibility with other
electrical and electronic equipment in the immediate vicinity of the system.
•
Ensure that:
-
Operating personnel have read and understood these operating instructions.
-
Anyone working near the device is made aware of the dangers and is provided with
the necessary protective equipment.
-
Repairs are only carried out by qualified persons.
•
In particular, make operating personnel aware of the safety instructions in this
document.
•
Always keep the system in fully functional condition.
•
Any modifications made to the device will invalidate the operating licence and the
warranty. Exception: Such modifications are expressly authorised by the manufacturer.
1.3
Impermissible operating conditions
The device must not be operated under the following conditions:
•
In explosive (Ex) zones
•
In areas with severe build-up of dust
•
In environments where the humidity is too high (see chapter 3 Technical data )
•
At altitudes of more than 2,000 m above sea level
•
Where there are strong vibrations
1.4
Emissions
The connected plasma generator produces the following emissions:
•
Certain amounts of ozone (O
Plasma gas
Air
BA-PZ2_ML / F0351301
). The workplace limit value may be exceeded. Example:
3
Gas flow
Ca. 20 l/min
Ozone
< 0.12 g/h
7
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
