Maintenance; Cleaning; Changing The Nozzle - Relyon plasma piezobrush PZ2 Betriebsanleitung

9

Maintenance

9.1

Cleaning

Only clean the outside of the plasma generator.
• Ensure that the plasma generator is disconnected from the power supply.
• Only clean the plasma generator with a cloth dampened in water. Do not use solvents
to clean the plasma generator!
9.2

Changing the nozzle

Proceed as follows:
• Ensure that the plasma generator is disconnected from the power supply.
• Press the catch buttons on both sides of the nozzle insert.
• Pull the nozzle insert out of the housing.
• Put the new nozzle insert in the housing. If necessary, press the catch buttons initially
and do not angle the insert.
• Apply a little pressure and slide the nozzle insert in until it engages in the lock position.
Attention – Damage to device!
Never touch the piezo crystal on the front side of the device with sharp-edged objects.
This component may be damaged by improper handling.
BA-PZ2_ML / F0351301 15