Troubleshooting - Sony UY-S100 Bedienungsanleitung

Troubleshooting

Before calling service personnel, please check your unit and consult the
Software Manual again. If it still doesn't work properly, ask your dealer.
The power does not turn on.
• Check the power cord is connected correctly. (page 8
• Check you pressed the POWER switch for two seconds or more. (page
16 )
(GB)
The power does not turn off.
• Check you pressed the POWER switch for two seconds or more. (page
16 )
(GB)
Scanning does not perform.
• Check the SCSI cables are connected correctly. (page 8
• Check both ends of SCSI interface are terminated. (page 10
• Check two SCSI ID devices have the same ID. (page 10
• Check the software is installed correctly. (See Software Manual)
Carrier does not move.
• Check if the carrier cover or lamp cover is open. (page 13
• Check you removed the packing materials.
• Check if the halogen lamp is burned out. (page 7
Scanned image appears strange.
• Check if you applied force to the carrier. Remove the carrier and mount it
again.
• Check the halogen lamp is turned on. Blocking the ventilation holes may
cause the lamp to turn off.
• Check if you applied vibration to the unit during scanning.
• Check if the halogen lamp is burned out. (page 7
• If you are using the slide carrier, check if you mounted the carrier with its
holder pushed in.
• Check the software is set up correctly. (See Software Manual)
Film cannot be fed properly.
• Check the curling condition or end conditions of the film. (page 17
• Check if the film is tangled or excessive force was applied to the film.
• Check if you mounted or removed the film carrier with film inside.
• Check dew condensation. (page 19
• Check the rollers inside the film carrier are clean. (page 20
• Check if film or tape is left in the film carrier.
)
(GB)
)
(GB)
(GB)
)
(GB)
(GB)
)
(GB)
)
(GB)
)
(GB)
(GB)
)
)
)
(GB)
)
21
(GB)