Location And Function Of Parts And Controls - Sony UY-S100 Bedienungsanleitung

Location and Function of Parts and Controls

1 POWER switch and indicator (green)
Press to turn the Film Scanner on or off.
The indicator lights up while the power is ON.
2 BUSY indicator (green)
Lights while the Film Scanner is in operation.
3 ALARM indicator (orange)
Lights when a problem occurs.
4 Carrier cover
Protects the carrier.
If the carrier cover is open, prescanning and scanning
cannot be performed. Also, opening the cover during
prescanning or scanning stops the operation. Make
sure to close the carrier cover.
5 Lamp cover
The halogen lamp is inside.
If the lamp cover is open, prescanning and scanning
cannot be performed. Also, opening the cover during
prescanning or scanning stops the operation. Make
sure to close the lamp cover.
Replacing the halogen lamp
The life of the halogen lamp is about 1,000 hours.
When the supplied lamp burns out, replace it with
the MPS-L60 lamp (not supplied).
For replacement of the halogen lamp, contact your
authorized Sony dealer.
6 Connector cover
The slide feeder connector is inside.
7 Slide feeder connector (D-sub 9-pin)
Connect the optional UYA-S90SF auto slide feeder.
Caution
This connector allows the connection of the UYA-
S90SF only. Never connect other equipment, as doing
so may cause electrical shock or damage to the
equipment.
8 Carrier
Use the correct carrier according to the types of film.
For details, see page 12 .
(GB)
Caution
To avoid injury, do not insert your hand or
fingers into the movable area of the carrier.
7
(GB)