Herunterladen Inhalt Inhalt Diese Seite drucken

Closing The Door; Replacing The Lamp; Installation - Electrolux EN3603OOW Benutzerinformation

Kühl - gefrierschrank
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

32
www.electrolux.com

8.2 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective
door gaskets. Contact the Service
Center.

8.3 Replacing the lamp

The appliance is equipped with
a longlife LED interior light.
CAUTION!
Disconnect the plug from the
mains socket.
1. At the same time, with the fingers
expand up and down the transparent
cover and unhook it in the direction of
the arrows.
9. INSTALLATION
9.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate
class
SN
N
ST
T
WARNING!
Refer to Safety chapters.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
1
2
1
2. Replace the lamp with one of the
same power and shape, specifically
designed for household appliances.
(the maximum power is shown on the
light bulb cover).
3. Reassemble the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door.
Make sure that the light comes on.
Some functional problems
might occur for some types of
models when operating outside
of that range. The correct
operation can only be
guaranteed within the specified
temperature range. If you have
any doubts regarding where to
install the appliance, please
turn to the vendor, to our
customer service or to the
nearest Service Centre
9.2 Location
The appliance should be installed well
away from sources of heat such as
radiators, boilers, direct sunlight etc.
Ensure that air can circulate freely around
the back of the cabinet. To ensure best
performance, if the appliance is positioned
below an overhanging wall unit, the
minimum distance between the top of the
cabinet and the wall unit must be at least
100 mm . Ideally, however, the appliance
should not be positioned below
overhanging wall units. Accurate levelling
is ensured by one or more adjustable feet
at the base of the cabinet.

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis