ZUMEX ESSENTIAL BASIC Bedienungsanleitung Seite 54

2
Fit the Elevation Kit legs.
There are four holes on the base of the machine marked in (Fig. 2), where the legs
go. The legs are supplied with some screw-in studs that are already fitted into the
ends of the legs. We must fully insert them into the holes (A) on the base and then
screw the legs in as far as they will go. Once this operation has been carried out
with all four legs, these can be mounted and removed when required without the
screw-in studs coming out of their housing.
3
Put the machine back into its working position.
Carefully stand the machine back up again leaving it in its working position.
A
Fig. 2
53