Cleaning Carpets And Rugs; Cleaning Wooden Floors; Using Wax Cleaners - Duplex STANDARD 340 Betriebs- Und Wartungshandbuch

CAUTION
The MOP-UP lever must only be moved when the appliance is stopped.
Thoroughly clean the appliance and brushes after cleaning extremely
dirty floors and before cleaning delicate floors.
WARNING
This procedure is not recommended for carpets, rugs and wooden
floors.
6.6.2

CLEANING CARPETS AND RUGS

Using the slider control, select the correct position (normal carpets / long pile carpets).
We advise you to cross the washed tracks so that all fibres appear well cleaned taking
care not to wet them too much.
(Make several trial runs before proceeding with the full washing operation).
6.6.3

CLEANING WOODEN FLOORS

Do not wet the floor excessively, especially non varnished floors that absorb water more
readily. In any case, be very careful with these types of floor and preferably
carry out a few tests before washing all of it.
6.6.4

USING WAX CLEANERS

The "Lavaincera" (wax cleaners) treatment system allows the entire surface to be thoroughly
washed, obtaining an optimal "polished look" and an instantaneous recovery of the dirt in
a simple, fast and cheap manner.
It is extremely suitable for the following floor types:
•
Terracotta
• Smooth tiles
•
Clinker
• Marble
•
Granite
• Studded rubber flooring
Proceed as follows:
1)
Use the appliance with the two grey brushes provided.
2) Fill the two tanks with the appropriate detergent (can be requested to the Manufacturer)
mixing it with water according to the instructions contained on the bottles;
3)
Proceed with the usual washing system.
Rev.
1.0
ASSEMBLING THE APPLIANCE
107
DUPLEX 340/420/620