Troubleshootings; Ec Declaration Of Conformity - SUNTEC KLIMATRONIC Heat Prime Bedienungsanleitung

TROUBLESHOOTINGS

Problem
The unit does not start.
EC-DECLARATION OF CONFORMITY
The unit complies with the essential health and safety requirements of the European Union. The EC declaration of
conformity is the basis for the CE marking of this unit.
With the publication of this manual, all previous are not valid. SUNTEC, SUNTEC Wellness, KLIAMTRONIC and
the Sun logo are registered trademarks. © 2014/03 SUNTEC WELLNESS GMBH
NOTE CONCERNING PROTECTION OF ENVIRONMENT
This product must not be disposed of via normal household waste after its service life, but must
be taken to a collection station for the recycling of electrical and electronic devices. The symbol
on the product, the operating instructions or the packaging indicates such disposal procedures.
The materials are recyclable in accordance with their respective symbols. By means of re-use,
material recycling or any other form of recycling old appliances you are making an important
contribution to the protection of our environment. Please ask your local council where your
nearest disposal station is located.
SUNTEC WELLNESS GMBH / HOLZSTRASSE 2 / 40221 DÜSSELDORF / DEUTSCHLAND
Cause
The overheat protection has been
activated.
The unit is not supplied with the
current.
®
© 2014 KLIMATRONIC
Solution
Turn the unit off, unplug it and let it
cool down. Verify that there are no
objects close to the device; if so –
please remove them. Wait 5-10
minutes and then turn the power on
again.
Check the power socket.
Make sure that the unit is on a flat
and stable surface so that the tip
safety cannot be activated.
HEAT PRIME
12