SUNTEC KLIMATRONIC Heat Safe compact 600 Bedienungsanleitung Seite 13

 To avoid the risk of electrical shock, fire or injury to
persons, always make sure that the heater is
unplugged from the electrical outlet before relocating,
servicing or cleaning it.
Parts Identification:
1
3
2
4
Safety Control (Thermal Cut-Out):
This model has two levels of over heat protection:
1) Automatic thermal cut-off: Switches off the heater in the event of overheating or malfunction and resets once
the temperature drops to a normal level.
2) Thermal fuse: In the event that the automatic thermal cut-off fails to operate the heater has a further safety
device. This is a non-resettable switch which will require the unit be returned to an Approved Service Agent for
replecement.
If overheating or malfunctions continue, return the heater to your retailer for examination.
Operating:

Place the heater in an upright position on a flat, steady, stable, heat-resistant surface. Make sure there is
nothing flammable or heat sensitive within 1 meter (40 inches). Operating the heater in any other position
could cause a hazard.

Insert the plug into a suitable wall outlet on an A.C. power supply having the same voltage as that show on
it's rating label after turning the thermostat knob counter-clockwise to the minimum position

Turn the thermostat knob clockwise to maximum position. When the temperature rises to with a comfortable
level, slowly turn thermostat counter-clockwise until the power indicator light just goes out. To adjust the
room temperature turn the thermostat clockwise to raise the temperature, or counter-clockwise to lower it.
Your unit will be automatically set an on-and-off cycle to maintain the current room temperature according to
thermostat setting. (Note: It normally requires approx. 15 minutes to reach the operating temperature.)

To turn the appliance off, turn the thermostat to "O" and remove plug from the wall socket.

Unplug the heater from the electrical outlet when it is left unattended or is not in use.
Care and Cleaning:
CAUTION: Allow the heater to completely cool before handling or cleaning it.
Ensure the heater is in the "O" OFF position and the Power Cord is unplugged from the electrical outlet before
cleaning the heater.

Always ensure the heater's housing is intact and completely assembled before each use.

Do not touch hot surfaces. Always use the handle of the heater. Use protective mitts or gloves to avoid
serious burns or other personal injury.

Clean the exterior surface of the heater by wiping it with a soft, damp cloth.
CAUTION: Do not allow water or other liquids to run into the interior of the heater, as this could create a fire
and/or electrical hazard.

Do not use any abrasive cleaners or solvents, as heater damage will occur.

Store the heater in a clean, dry place when it is not in use.
1. Carry Handle
2. Thermostat Knob
3. Switch & Indicator Light
4. Front Feet
5. Rear Feet
6. Radiator Fins
5
6