Herunterladen Diese Seite drucken

SUNTEC KLIMATRONIC Heat Safe compact 600 Bedienungsanleitung Seite 12

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
 To prevent a possible fire, do not block air intakes or
exhaust openings in any manner. Do not use on soft
surfaces, like a bed, where openings may become
blocked.
 WARNING: In order to avoid overheating, do not
cover the heater.
 To avoid a circuit overload when using this heater, do
not operate another high-wattage heater on the same
electrical circuit.
 Avoid the use of an extension cord because the
extension cord may overheat and cause a risk of fire.
 Do not allow the Power Cord to hang (i.e., over the
edge of a table or counter) or place/run the Power
Cord under rugs or in high-traffic areas where it may
be tripped over or pulled.
 Do not put any stress on the Power Cord where it
connects to the heater, as the Power Cord could fray
and break.
 Do not plug or unplug the heater from the electrical
outlet with a wet hand.
 Keep the Power Cord and heater away from heated
surfaces.
 If the supply cord is damaged return the heater to your
market.
 The heater must not be located immediately below a
socket-outlet.
 When scrapping the heater, follow the regulations
concerning the disposal of oil.
 The heater should not be used in a room, of which the
floor area is less than 5 M
 Use this heater only as described in this manual. Any
other use not recommended by the manufacturer may
cause fire, electric shock, or injury to persons.
2
.

Werbung

loading