Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATING INSTRUCTIONS
INSTALLATION
The heater must be installed as above diagram.
The heater must be installed at least 1, 8 m above the floor.
The heater must be installed at least 300mm away from the wall or ceiling.
Whenever the appliance is to be installed in a bathroom, it is necessary to maintain the required safety
zone around it.
Do not install the appliance so that the heat rays directly beat on walls or adjacent objects.
For fixture to a wall, proceed in the following manner.
－Unscrew by one turn the screw A which determines the inclination of the appliance.
－Turn the wall support to the end of its travel.
－Unscrew the screw which fastens the cover of the wall support and remove the cover.
－Determine the placement of the appliance and, with the help of the holes of the holes are to be drilled in the
wall.
－Drill two 6mm holes and insert the supplied dowels.
－After installed, the supply cord must not contact the metal enclosure when used.
ELECTRICAL CONNECTION
The power cord: Material: PVC NR.3 wires
(neutral, live, earth) Section: 1mm²(minimum)/
Sheath: 10mm (maximum diameter)
Once the power cord is inserted through the wall support, attach the support by means of the supplied screws
and dowels which were previously inserted into the wall.
Remove the screw from the cable in the cable clamp, and place the cable in the provided seat. Make sure that
the wires connections correspond to the stamped symbols on the support.
WARNING THIS APPLIANCE MUST BE EARTHED
IMPORTANT
The wires in the cord are colored in accordance with
the following: Green and yellow Earth
Blue:
Neutral
Brown:
Live
The green and yellow wire must be connected to the terminal marked with the letter E or the earth symbol.
The blue wire must be connected to the terminal marked with the letter N or colored black. The brown wire
must be connected to the terminal marked with the letter L. Clamp the wires, to the cable holder by means of
the screw B.Put the cover back into its place on the wall support and fasten it by means of the appropriate
screw .Unscrew by one turn the screws which regulate the inclination of the appliance. Determine the desired
heating inclination and fasten the screw by means of the screws (A). Do not change the inclination without
loosening the appropriate screws. Otherwise permanent damage could be caused to the appliance.
IMPORTANT
During the assembly is important to be especially careful to touch with the heating elements as this could
leave spots which would diminish the thermal radiation.
Werbung
