How To Load Rinse Aid; Loading The Rinse Aid - Haier DW12-PFE8-Serie Bedienungsanleitung

How to load rinse ald
Rinse aid
This product makes dishes sparkle and helps them
to dry without spotting. The dispenser is located
on the inside panel of the door .When the low rinse
aid indicator " I "on the control panel and the
mechanical indicator " 1 " on the dispenser light,
you must load rinse aid.
Notice:
When using combi-detergent tablets,like "3 in 1", "4 in 1",
"5 in 1"... the rinse-aid is no longer useful.

Loading the rinse aid

Regardless of the type of detergent dispenser
installed on your appliance, you must proceed as
indicated below when loading the rinse aid.
To open the dispenser, turn the "2" cap in an anti-
clockwise direction and then pour in the rinse aid,
making sure not to overfill. The amount of rinse
aid used for each cycle can be regulated by turning
the " 3" dose adjustor, located beneath the "2"
cap, with a screwdriver. There are 6 different
settings; the normal dosage setting is 3.
Important:
Proper dosage of the rinse aid improves drying. If drops
of water remain on the dishes or spotting occurs, the
dosage adjustor should be turned to a higher setting. If
the dishes have white streaks, turn the dosage adjustor
to a lower setting.
15
EN
I
1
2 3