Omnitronic WAMS-65BT Bedienungsanleitung Seite 21

No. Element
1 Audio player
2 Memory card slot
3 USB port
4 Infrared sensor for the
remote control
5 Remote control
6 Microphone input
7 Level control
8 Line input
9 Level control
10 Link output
11 Level control
12 Level control
13 Receiver on/off
14 Intensity control
15 Tone control
16 Level control
17 Reception indicator
18 Clip indicator
19 Power indicator
20 Charging indicator
21 Power on/off
22 Power input with fuse
holder
Battery compartment cover
23
24 Wireless microphone
Function
MP3 player with built-in Bluetooth receiver and 5 operating buttons.
[MODE]: Short actuation: for switching between the USB, SD and
Bluetooth operation. / Long actuation: for switching the player on/off.
[ /VOL-] / [ /VOL+]: Short actuation: for title or folder selection. / Long
actuation: for volume adjustment.
[REPEAT]: for selecting random play and repeat functions.
[►II/FOLDER]: Short actuation: for switching between play and pause. /
Long actuation: for switching over to folder selection mode.
For inserting an SD(HC) card.
For connecting a USB storage device.
When actuating a button, always direct the remote control towards the
sensor. There must be no obstacles between remote control and the
sensor.
[►II]: For switching between play and pause.
[CH-] / [CH+]: For folder selection.
[EQ]: For selecting equalizer settings.
[‒] / [+]: For volume adjustment.
[ ] / [ ]: For title.
[0-9] and [PICK SONG]: Numerical keys for direct selection of a title.
[ENTER]: For selecting random play and repeat functions.
[MODE]: For switching between the USB, SD and Bluetooth operation.
XLR input for connecting a microphone to channel 1.
To mix the microphone signal of channel 1 to the master signal.
Stereo input (RCA L/R) jack for connecting audio units with line level
(e.g. CD player) for channel 2/3.
To mix the line signal of channel 2/3 to the master signal.
6.3 mm jack to feed the mixed signal (mono) to units with line level
inputs, e.g. another PA system.
To mix the audio player signal to the master signal.
To mix the signal of the wireless microphone to the master signal.
Switches the receiver module on/off. The LED below the button indicates
that the receiving unit is powered on.
Adjusts the intensity of the internal echo effect applied to channel 1 and
the wireless microphone.
Tone control for the mixed signal. In the left half the high range is
attenuated, in the right half the low range is attenuated.
Controls the overall level.
Lights when an audio signal from the wireless microphone is received.
The PEAK LED lights if the internal power amplifier section is
overloaded. Reduce the volume of the signal sources accordingly.
Lights when the PA system is powered on.
• Lights red: battery is being charged.
• Lights green: battery fully charged/mains operation.
Switches the PA system on/off.
Used to plug in the supplied power cord. Only replace the fuse when the
device is disconnected from mains. Only use fuses of the same rating
and power.
Remove the cover to insert a rechargeable battery.
With on/off/mute switch and battery indicator.
21