Tack life PSFS1A Bedienungsanleitung Seite 8

■■ Ensure that your workplace is adequately ventilated.
■■ Observe the regulations applicable in your country regarding the materials to be worked.
■■ Wear a dust mask.
Dust extraction using the dust box
♦♦ Press the dust box
with the adapter fitting
Dismantling / removing the dust box
♦♦ Pull the dust box
Connect the external extraction adapter
♦♦ Push the external extraction adapter
If necessary, use the reducer
♦♦ Push the hose from a suitable dust extraction device (e.g. a workshop vacuum cleaner)
onto the external extraction adapter
Removal:
♦♦ Pull the vacuum cleaner hose off the reducer.
♦♦ Pull the external extraction adapter
Operation
Switching on and off
During operation, you can choose between instant-aneous and continuous operation.
Switching to instantaneous operation:
♦♦ Press the ON/OFF switch .
Switching off instantaneous operation:
♦♦ Release the ON/OFF switch .
Switching to continuous operation:
♦♦ Press the ON/OFF switch
Switching off continuous operation:
♦♦ Press the ON/OFF switch and release it.
Selecting speed and abrasive belt
You can use the setting wheel for belt speed
running. The optimum belt speed is dependent on the work-piece or material to be processed..
Determine the correct speed by carrying out practical tests. The table below contains recom-
mended values to help you with your investigations.
Stationary work
♦♦ Turn the power tool over as shown in Figure C and place it on a stable worktop.
:
into the notch provided for this purpose on the side of the appliance
.
:
off the appliance.
onto the adapter fitting
by pushing it onto the external extraction adapter
(with the reducer
(with the reducer
, keep it pressed in and then press the locking button .
(with reducer ):
if necessary).
if necessary) off.
to select the speed even if the appliance is
06
.
.