DeLonghi EC820 Bedienungsanleitung Seite 81

Problem
The co ee cream is dark (the co ee ows
slowly from the spout)
The milk does not froth when making a
cappuccino
Electrical connection (UK ONLY)
Before using this appliance ensure that the voltage indicated on the
product corresponds with the main voltage in your home, if you are
in any doubt about your supply contact your local electricity company.
The exible mains lead is supplied connected to a B.S. 1363 fused plug
having a fuse of 13 amp capacity. Should this plug not t the socket
outlets in your home, it should be cut o and replaced with a suitable
plug, following the procedure outlined below.
Note: Such a plug cannot be used for any other appliance and should
therefore be properly disposed of and not left where children might
nd it and plug it into a supply socket - with the obvious consequent
danger.
Please note: We recommend the use of good quality plugs and wall
sockets that can be switched o when the machine is not in use.
IMPORTANT: The wires in the mains lead tted to this appliance are
coloured in accordance with the following code:
Green and Yellow to Earth
GREEN AND YELLOW EARTH
BLUE NEUTRAL
BROWN LIVE
Blue to
neutral
Possible causes
The ground co ee is too tightly pressed
Too much ground co ee
The espresso boiler outlet is blocked
The lter is blocked
The co ee is too nely ground
The ground co ee is too ne or is damp
Incorrect type of ground co ee
Milk not cold enough
Cappucccino maker is dirty
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
- The wire which is coloured green and yellow must be connected to
the terminal in the plug which is marked with the letter E or by the
earth symbol
- The wire which is coloured blue must be connected to the terminal
which is marked with the letter N or coloured black.
- The wire which is coloured brown must be connected to the termi-
nal which is marked with the letter L or coloured red.
When wiring the plug, ensure that all strands of wire are securely retai-
ned in each terminal. Do not forget to tighten the mains lead clamp on
the plug. If your electricity supply point has only two pin socket outlets,
or if you are in doubt, consult a quali ed electrician. Should the mains
lead ever require replacement, it is essential that this operation be car-
ried out by a quali ed electrician and should only be replaced with a
exible cord of the same size. After replacement of a fuse in the plug, the
fuse cover must be re tted. If the fuse cover is lost, the plug must not be
used until a replacement cover is obtained. The colour of the correct re-
placement fuse cover is that of the coloured insert in the base of the fuse
13 amp Fuse
recess or elsewhere on the plug. Always state this colour when ordering
a replacement fuse cover. Only 13amp replacement fuses which are asta
approved to B.S. 1362 should be tted.
Brown to live
This appliance conforms to the Norms EN 55014 regarding the suppres-
Cord Clamp
sion of radio interference.
Warning - this appliance must be earthed
80
Troubleshooting
Solution
Decrease the amount of ground co ee
Reduce the quantity of ground co ee
Clean as indicated in "Cleaning the lter"
Only use co ee ground speci cally for
espresso co ee machines and it must not
be damp
Change the quality of the ground co ee
powder
Only use co ee ground speci cally for
espresso co ee machines and it must not
be damp
Change the quality of the ground co ee
powder
Always use milk at refrigerator
temperature
Carefully clean the holes in the
cappuccino nozzle
or coloured green or green and yellow.
gb