Vimar Elvox RS06 Anschluss- Und Bedienungsanleitung Seite 40

Parameter table
Parameter
number
P01 Enables automatic closing
P02 Sets the automatic closing time
P03 AP/CH input operation
P04
P05 Closing after photocell disengagement
P06 Type of safety device connected to the STPA input
P07 AUX output operating mode
P08 Enables photocell control
P09 Slowdown distance when closing
P10 Slowdown distance when opening
P11 Opening speed
P12
P13 Opening deceleration speed
P14 Closing deceleration speed
P15
P16 Intensity of stopping with opening limit switch tripping
P17 Intensity of stopping with closing limit switch tripping
P18 Separate buttons
P19 Operating logic of the PHOTO input
P20 Selects the operation of the second button on the
P21 Channel 2 output activation time
P22 Pedestrian opening distance
P23
P24 Acceleration on starting
P25 Deceleration on slowing down
P26
P27 Flashing light active also when running only on
P28 Operation with battery
P29 Manned, AP/CH controls opening by keeping the
button pressed, PED controls closing by keeping the
button pressed
P30
P31 Selecting the direction of opening the gate
38
Description
Pre-flash
Closing speed
Motor force
remote control
-
-
battery
-
Settable values
ON/OFF
2-600 seconds
1= when opening, AP/CH input not active (condo)
2=AP/CH as sequential (open, stop, close, stop..)
3=AP/CH as sequential (open, open, close..)
ON/OFF
ON/OFF
1= photocell as protection on opening
(if engaged it stops the gate, until it is disengaged, and then it con-
tinues in the same direction)
2= microswitch sensitive edge
3= resistive sensitive edge (balanced with resistance
of (8.2Kohm)
4= photocell as internal protection (if engaged it stops the gate,
until it is disengaged, then it
continues opening)
1= disabled
2= flashes while the gate is moving
3= flashes while the gate is moving and stays on steady when the
gate is stationary
0= Control disabled, 1= Control on PHOTO input
2= Control on STPA input, 3= Control on STPA and PHOTO inputs
0-150cm
0-150cm
50-100%
50-100%
20-75% - Minimum speed 20%
20-75% - Minimum speed 20%
Min. 1-10 max
0-10, 10= instantaneous stop, 0= soft stop
0-10, 10= instantaneous stop, 0= soft stop
0= AP/CH controls opening and closing the gate completely, PED
controls partial gate opening and closing
1= input AP/CH, controls opening only and input
PED, controls closing only
2= input AP/CH and the button of the remote control saved as CH1
controls opening only and the PED input and the button of the re-
mote control saved as CH2 controls closing only
1: the PHOTO input tripping reverses the movement of the
gate during closing
2: the PHOTO input tripping stops the movement of the gate during
opening and closing, when disengaged it goes back to opening again
2CAN= activates the 2CH output
PEDO= controls pedestrian opening
1-60 seconds
50-250 cm
-
1-5 (1=maximum acceleration 5= minimum acceleration)
1-8 (8= maximum deceleration 1= minimum deceleration)
-
ON/OFF
0: functionality does not change
1: after an apch command the gate opens and remains open
2: the gate opens and remains open
0: function disabled
1: function active if the safety devices are open (PHOTO and
STPA)
2: function active with APCH and PED inputs, maintains automatic
operation if controlled remotely
-
OFF: Opens to the left
ON: Opens to the right
Default Modified
value value
ON
60 seconds
1
ON
OFF
1
2
0
73 cm
49 cm
100%
100%
50%
50%
5
5
5
0
1
PEDO
1 sec
148 cm
-
3
7
-
OFF
0
0
OFF
EN