Vimar Elvox RS10 Installations- Und Benutzerhandbuch Seite 25

RS10
Display Message Description
Used to save the remote control button corresponding to the
1 CH
input APCH
Used to save the remote control button corresponding to the
2 CH
input PED or output 2CAN
Pressing the button on the remote control lets you compare and
CTRL
see the memory location where it has been saved.
Used to delete a remote control in the memory list or all the
ERAS
remote controls in the memory.
N.B. The first saved remote control configures the control panel to accept only remote controls with a rolling code or only remote controls with
a fixed 12-bit code.
Note: It is advisable to fill in the final table indicating the number of the memory cell (it is displayed while saving the remote control) in the user
name, this enables deleting a remote control should it get lost.
6.3 - LRN:
Learning travel with custom programming lets you define the points for starting deceleration when both opening and closing
N.B.: Before you start programming, check parameter 18 (opening direction)
If the gate opens to the right, set parameter 18 (opening direction) to R.
If the gate opens to the left, set parameter 18 (opening direction) to L
APERTURA
OPENING
Display message after activating the remote control
(memory location occupied by the remote control just saved)
(memory location occupied by the remote control just saved)
First character of the display:
- channel associated with the saved remote control button
(1 or 2)
Last three characters of the display:
- memory location occupied by the remote control just saved
1. Press OK until ALL appears on the display. Release OK
To delete all the remote controls:
- press and hold OK until oooo appears on the display
To delete a single remote control:
- scroll with the UP or DOWN buttons until the memory loca-
tion occupied by the remote control which you want to dele-
te, press and hold OK until the display shows oooo (deleting
a remote control from the memory position clears the asso-
ciations of both the first and the second channel)
APERTURA
OPENING
EN
Parameter 18
on R
Parameter 18
on L
23