Troubleshooting - EINHELL GC-HM 40 Originalbetriebsanleitung

10. Troubleshooting

If the equipment is operated properly you should experience no problems with malfunctions or faults.
In the event of any malfunctions or faults, please check the following before you contact your customer
services.
Problem
Unusual noises
Unsatisfactory cut-
ting results
The reprinting or reproduction by any other means, in whole or in part, of documentation and papers
accompanying products is permitted only with the express consent of the iSC GmbH.
Subject to technical changes
Anl_GC_HM_40_SPK7.indb 18 Anl_GC_HM_40_SPK7.indb 18
GB
Possible cause
- Loose screws/parts?
- Foreign bodies in the blade?
- Damaged blade?
- Wrongly adjusted bladed?
- Wrongly adjusted bladed?
- Blunt blade?
- 18 -
Remedy
- Tighten the screws
- Remove the foreign bodies
- Have the blade replaced
- Set the counter blade (see 7.2.1)
- Set the counter blade (see 7.2.1)
- Have the blade sharpened or repla-
ced
02.06.15 12:01 02.06.15 12:01