Rear Panel - Denon DN-300CR Schnellstartanleitung

Rear Panel

2 3
1. Power Input: Use the included power cable to connect this input to a power outlet.
2. Analog In (unbalanced RCA): Use RCA cables to connect an external audio source to these
inputs.
3. Analog Out (unbalanced RCA): Use RCA cables to connect these outputs to external speakers,
sound system, etc.
4. Analog Out (balanced XLR): Use XLR cables to connect these outputs to external speakers,
sound system, etc.
5. Digital Coaxial In/Out: Use digital coaxial RCA cables (IEC60958 Type II S/PDIF compatible) to
connect this input and output to your sound system.
6. Digital Optical In/Out: Use digital optical TOSLINK cables (IEC60958 Type II S/PDIF
compatible) to connect this input and output to your sound system.
Setup
Important: Connect all cables securely and properly (with stereo cables: left with left, right with
right), and do not bundle them with the power cable.
1. Use stereo RCA cables, a digital coaxial cable, or a digital optical cable to connect the outputs
of your audio sources to the Inputs (unbalanced or digital) of DN-300CR.
2. Use XLR cables, stereo RCA cables, a digital coaxial cable, or a digital optical cable to connect
the Outputs (balanced, unbalanced, or digital) to the analog or digital inputs of your external
receiver, amp, powered monitors, etc.
3. After completing all the connections, use the included power cable to connect the Power Input
to a power outlet.
4. Power on all of your input sources.
5. Power on DN-300CR.
Mixer
Items not listed under
4
5 6
Powered Monitors
Introduction > Box Contents are sold separately.
1
Power
Receiver
5