Other Functions; Cleaning And Care - AEG KM7 serie Gebrauchsanweisung

Other functions

D
1. Attachment hub: The appliance
comes with a built in multipurpose
attachment hub. You can remove the
attachment cover (A) by pressing the
attachment knob (D) upwards. It is
possible to purchase meat mincer,
pasta accessories and vegetable
shredder as additional accessories.
Kindly see www.electrolux.com for
more information.

Cleaning and care

1. Switch the appliance off, remove
the plug from the wall socket and
wait until the tools have stopped
completely.
Warning! Never immerse the
housing, plug, or cord in water or any
other fluid.
A
2. Adjusting the tool shaft:
The appliance is adjusted at the
factory so that the attachment
clears the bottom of the bowl. If the
attachment hits the bottom of the
bowl or is too far away from the sides,
you can adjust it correctly.
See 3 for further instructions.
Note: Make sure the attachment is as
close to the bottom of the bowl as
possible for best results.
2. Wash all parts, except for the motor
base, in warm soapy water. Dry each
part thoroughly before use.
If using the dishwasher, place
parts only on the top rack of your
dishwasher.
Note: The bowl lid* and bowl cover*
are not dishwasher safe.
A
3. Release the nut on the shaft of the
tool. If the tool scrapes the bottom
of the bowl: Loosen the nut (A),
screw shaft (B) downward into the
tool. Fasten the nut (A). If the tool is
to far away from the sides/bottom
of the bowl: Screw the shaft (B)
upwards. Fasten the nut (A).
3. The housing should only be cleaned
with a soft damp cloth, then dried
with a cloth.
Note: Do not use abrasive cleansers or
scouring pads to clean the surfaces of
your appliance.
Store the power cord in the cord
storage (manual rewind) - push the
cord inwards into the hole on the rear
of the appliance.
D
B
GR
NL
F
C
GB
27