Radio Operation - auna 10022749 Bedienungsanleitung

1. Press the MODE button on the main unit (or remote control) to select the TUNER mode that to
select the FM operation.
2. Select the desired frequency with the SKIP/TUNE SEARCH (UP or DOWN) button on the main unit
(or remote control).
Mono/Stereo Select
This unit can receive the FM mode only.
1. When you want to select FM stereo station, press the SELECT button on the remote control once
only. The „ „ indicator will appear on the display that the reception is at its best.
2. When you press the SELECT button once again, the FM STEREO indicator will turn off & switch to
MONO FM status.
Automatic Tuning
1. Press the SKIP/TUNE SEARCH (UP or DOWN) button for a few seconds, and then release the
button. The tuner will automatically search the first station of sufficient signal strength.
2. Repeat above procedure if you wish to select another station.
Programming preset stations
You can also preset stations of your choice and store up to 30 FM stations in its memory.
1. Tune to the required station.
2. Press the MEMORY button.
3. Press the PRESET/FOLDER (UP or DOWN) button for your desired station number.
4. Press the MEMORY button again to confirm your selection.
5. To program more stations into memory, repeat the above steps 2 to 4.
6. To change the stored preset stations, repeat the above steps 2 to 4.
Notes:
1. Storing a new station into a preset location will erase the previously stored station in that location.
2. Power off will not erase the memory of preset stations. Perform the stations presetting procedures
again to store the stations.
3. During the unit in STANDBY mode, press and hold the PLAY/PAUSE button to erase all preset
memory.
Selecting the Preset Stations
1. Press the PRESET/FOLDER (UP or DOWN) button to select the desired preset station number.
2. The numeric location of that preset station is displayed along with the corresponding frequency.
FM Antenna
Extend the FM antenna for better FM reception.
Listening To Compact Disc (CD/MP3/WMA)
1. Press the MODE button on the unit to select the CD mode.
2. Press the CD OPEN/CLOSE button on the main unit (or remote control), and then the CD door will
open automatically.
3. Insert the CD/MP3 disc into the CD compartment, press the OPEN/CLOSE button again to close
the CD door. The main unit will read the CD/MP3 disc automatically.
NOTE:
1. This unit can play CD, CD-R, CD-RW, MP3 and WMA discs. (2) It can read „ 8 cm „ and „ Multi
Section „ MP3 DISC.
2. The „Playback Transfer Rate" in MP3 and WMA. (a). In MP3, transfer bit rate : 8 - 256 kbps. (b).
In WMA, transfer bit rate : 8 - 192kbps.
3. The „Max Readable 99 folders and 999 tracks".
4. If no disc or can`t read TOC, NO DISC will be displayed.

Radio Operation

CD/MP3/WMA Operation
16