Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Connecting the fixture to 12 V
The already installed lamp means the fixture is immediately ready for
use. Therefore you do not need to install the lamp first.
Step 1
Remove the mounting plate (A) using the removal tool (B). (Fig. 1)
There is a hole in the middle of the mounting plate to feed the cable
through. Make a hole of at least 13 mm / 0.5 inch Ø in the mounting
surface in the position where you want to mount the fixture to feed the
cable through. You can use the supplied template. Attach the mount-
ing plate to the surface with the screws provided. (Fig. 2)
Note: retain the removal tool in case you want to move the fixture in
the future.
Step 2
Hook the fixture over the rim of the mounting plate and click the fixture
back into place against the mounting plate. (Fig. 3)
Step 3
Join the Easy-Lock connector to the main cable. (Fig. 4)
a. Clamp the cable duct on top of the main cable.
b. Place the cable duct (with the cable at the bottom) in the Easy-
Lock connector.
c. Tighten the threaded cap on the Easy-Lock connector. This will
cause the contacts to be pushed through the insulation on the
cable. In tightening the cap, a little gel is applied to the contacts in
the Easy-Lock connector. This serves to protect the contacts
against moisture. A little gel may possibly come out of the Easy-
Lock connector: so after installation (and/or before a meal), wash
your hands with soap and water, and avoid the gel coming into
contact with your eyes.
Step 4
Connect the main cable to the fixture by connecting the mini-
connector. (Fig. 5)
If the lamp does not work correctly, check that the Easy-Lock connec-
tor is properly connected to the main cable. Do the same for the mini-
connector. Repeat steps 3 and 4. When the fixture is connected to the
main cable also check that the contacts of the Easy-Lock connector
are not bent. If you have any problems, contact your dealer.
General maintenance advice
We advise wiping the fixture down at least once a year using a clean
cloth and warm water.
Werbung
