Remington MB320C Bedienungsanleitung Seite 6

ENGLISH
, TRIMMING THE NAPE OF YOUR NECK
, Note: You will need a hand mirror for this operation if performing it alone.
• Remove the trimmer comb attachment.
• Use your fingers to lift the hair at the base of your head up off the neck. Your
index finger should be covering the roots of the hairs you are lifting to
prevent accidental removal by trimmer.
• Using your other hand, hold the trimmer to the base of your neck with the
cutting unit facing up and move the trimmer up the length of the neck until
it touches your finger, covering the hair roots at the base of your head.
• Be sure to move the unit slowly when performing this operation and to keep
the hair roots at the base of your head out of the way of the trimmer.
, REMOVING THE CUTTING ASSEMBLY
• Remove the cutting assembly by firmly pushing up on the blade with your
thumb.
, REPLACING THE CUTTER ASSEMBLY
• Hold the trimmer in one hand. With your other hand, insert the lower part of
the cutter assembly into the trimmer, push down the cutter until firmly
attached.
E TIPS FOR BEST RESULTS
• Beard, moustache and sideburn hairs should be dry.
• Avoid using lotions before use.
• Comb your hair in the direction that it grows.
• Remove the trimmer comb attachment if you are; defining hairline edges
such as sideburns, trimming the nape of your neck or trimming your beard
line on front of neck.
C CARE FOR YOUR TRIMMER
• Care for your product to ensure a long lasting performance.
• Your trimmer is fitted with high-quality, cutting blades that are permanently
lubricated.
• Cleaning should only be done with a soft brush.
, AFTER EACH USE
• Turn the groomer off.
• Remove the trimmer comb attachment and cutter assembly.
• Gently brush the remaining hairs away from the trimmer comb and trimmer
blade.
• Do not rinse the cutter assembly under water.
6