Sennheiser RS 60 Gebrauchsanleitung Seite 14

Adjusting the volume
Set the volume of your sound source to a
medium value. With some devices, the volume
for the headphone output can be regulated
separately.
Use the V control on the right earpiece to
OLUME
adjust the headphones´ volume.
Adjusting the receiver channel
Turn the T control on the earpiece until you
UNE
can hear the audio signal loud and clear.
Changing the transmission channel
To avoid interference caused by the
simultaneous operation of several transmitters,
select a different channel on each transmitter.
Depending on the system variant, two or three
switchable transmission channels are available.
To select a channel, press the C
until the desired LED or LED combination
lights up:
LED 1
LED 2
LED 1 and 2
Complete freedom of movement
It is not necessary that transmitter and
headphone receiver are in a direct line of sight,
so you can move around freely in the home or
outside in the garden. One transmitter can be
used to transmit to several receivers on the
same frequency.
Additional headphones with the designation
HDR 60 are available from your specialist
dealer. Please make sure to choose
headphones with the same frequency range as the transmitter you are using
(see type plate on the bottom of the transmitter).
Wireless RS 60-8
button
HANNEL
channel 1 active
channel 2 active
channel 3 active (except 863 MHz version).