High Temperature Alarm; Fastfreeze Function; Daily Use; Cleaning The Interior - Electrolux FI23/11NDV Benutzerinformation

8 www.electrolux.com
The fan inside the
refrigerator compartment is
automatically activated also
when the room temperature
is high (over 32°C) or for a
quick temperature
recovering after door
opening, even though the
Shopping function is not
activated.
It is possible to de-activate
the function at any time by
pressing MODE (refer to
"Functions Menu").
3.10 FreeStore function
The function is activated by pressing the
MODE (several times if necessary) until
the corresponding icon appears .
In this condition the fan works
continuously.
It is possible to deactivate the function at
any time by pressing the MODE until the
icon goes out of view.
If the function is activated automatically
the FreeStore icon is not shown (refer to

"Daily use").

The activation of the FreeStore function
increases the energy consumption.

3.11 FastFreeze function

To freeze fresh food, you will need to
activate the FastFreeze function.
Press MODE (several times if necessary)
until the corresponding icon appears.
4. DAILY USE
WARNING!
Refer to Safety chapters.

4.1 Cleaning the interior

Before using the appliance for the first
time, the interior and all internal
accessories should be washed with
lukewarm water and some neutral soap
to remove the typical smell of a brand-
new product, then dried thoroughly.
This function stops automatically after 52
hours.
It is possible to deactivate the function at
any time by pressing MODE (refer to
"Functions menu").

3.12 High temperature alarm

An increase in the temperature in the
freezer compartment (for example due to
a power failure) is indicated by:
• flashing temperature
• freezer compartment flashing
(Freezer compartment indicator)
• sounding of buzzer
• red illumination of display
When normal conditions are restored:
• the acoustic signal shuts off
• the temperature value continues to
flash
• the display illumination remains red.
When you press MODE / Alarm reset
switch to deactivate the alarm, the
highest temperature reached in the
compartment appears on indicator
for few seconds.
At this point the flashing stops and the
display illumination changes over from
red to white.
During the alarm, the buzzer can be
switched off by pressing MODE / Alarm
reset switch.
The illumination of the display remains
red until normal storage conditions are
restored.
CAUTION!
Do not use detergents,
abrasive powders, chlorine
or oil-based cleaners as they
will damage the finish.