Viking ME 545 C Gebrauchsanleitung Seite 44

Troubleshooting
Fault
- Motor will not start
- Frequently tripped mains fuse
- Excessive vibration during
operation
- No response when wheel
drive lever is actuated
(on ME 545 V)
16
Possible cause
- No mains voltage
- Connection cable/plug or plug
connector or switch defective
- Start button not pressed
- Thermal motor overload
protection has been triggered
- Mower housing is blocked
- Unsuitable connection cord
- Power overload
- Appliance is overloaded due
to mowing grass which is too
long or too wet
- Blade fastening screw is loose
- Motor mounting is loose
- Blade imbalance due to
incorrect re-sharpening or
fracture
- Wheel drive cable incorrectly
adjusted
- V-belt worn
- Wheel drive cable damaged
(e.g. kinked)
- Gearbox is defective
see motor instruction manual
If necessary, contact a specialist dealer; VIKING recommends VIKING specialist dealers.
Remedy
- Check fuse
- Check, replace if necessary
- Press start button
- Allow appliance to cool, then
try again to start
- Clean mower housing
(disconnect mains plug before
cleaning)
- Use suitable connection cord
- Connect the appliance to
another circuit
- Work at appropriate cutting
height and mowing speed for
mowing conditions
- Tighten blade fastening screw
- Tighten motor fastening bolts
- Re-sharpen (balance) or
replace blade
- Re-adjust wheel drive cable
- Replace V-belt
- Replace wheel drive cable
- Replace gearbox
Page Illustration
9
10 11
8, 9,
11 16
9
9
7, 9 7
19
12,
18, 19
12,
13 20
0478 121 9909 E - EN