Advanced Features; Run A Zone Manually - Nelson SmartZone EZ Installations- Und Programmieranleitung

ADVANCED FEATURES

The SmartZone
controller or allowing you to bypass the current program to water immediately. The following
section will show you how to set up the controller to:
•

run a zone manually

•
run a program manually
•
run a 3 minute test of every programmed zone
NOTE: All test procedures are run with the MODE dial in the AUTO position. This allows the
controller to reset to the AUTO setting after running a manual/test procedure. It also
allows you the ability to walk away from the controller after setting up a manual/test
procedure and not have to come back to reset the controller to AUTO.
NOTE: All manual/test procedures ignore the sensor connection. Therefore, you can water
utilizing one of the manual/test procedures even if the sensor has suspended your
scheduled program.
Run a Zone Manually
Turn the large dial to the MANUAL position. The default of zone 01 and 00:10 minutes will be
flashing (recall that this means you can change them). Press SELECT
number that you want to run. Press ADJUST
controller will delay 10 seconds before starting the zone.
EZ incorporates three manual/test procedures for checking the function of the
TM
to set the run time for the selected zone. The
to select the zone
20