Video Source Menu; Rf Learning Connections - Dell 5100MP Benutzerhandbuch

Video Source Menu

NOTE:
This menu is only available with S-video, Video (composite) signal
connected.

RF Learning Connections

36 Using Your Projector
S —Adjust a video source from black
ATURATION
and white to fully saturated color. Press
decrease the amount of color in the image and
to increase the amount of color in the
image.
S —Press
HARPNESS
sharpness and
to increase the amount of
T —Press
INT
green in the image and
amount of red in the image.
Auto Learning to Change RF Channel Between
Remote Controller and Projector
• Power on the projector.
• Press the "Menu" button on control
panel, then enter to "Management--
>RF_Ch Learning " menu.
• Select Yes with the control buttons to
enter the Learning Standby mode. The
projector will switch to standby mode
for RF Learning and display the RF
Learning menu.
• Open the battery cover on the remote
control and press the Prgm button to
initiate the RF Learning process for the
remote control and projector.
Back to Factory Default for the RF Channel
• Select Yes on RF Learning Setting
menu and then enter the RF Reset to
Default menu. Select Reset to Default
Channel, the projector will back to the
factory default channel.
to decrease the
to increase the sharpness.
to increase the
to