Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Fill the Icepacks with cold, clean water.
• It is recommended that a 24 hour pre-cooling be undertaken before the icepacks are inserted.
• Do not make attempts to cool Icepacks during the cooling phase immediately following the setting into operation of
the device.
• Best transmission of the cooling temperature can be obtained, when the Icepack is pressed to the evaporator as
hard as possible.
• 8 Icepacks can be frozen within 15 hours when the device is operated under normal conditions (i.e. ambient tem-
perature not exceeding 32°C) and with continuous cooling operation.
• Place the Icepacks upright in the freezer section using the icepack-holders corresponding to the figure below.
• The refrigerator should be cleaned inside and outside before it is set into operation and afterwards at regular inter-
vals.
• Use lukewarm water with a mild cleaning agent. Abrasive or caustic cleaning agents, steel wool, scouring sponges,
or chemical cleaning agents should not be used under any circumstances.
• After the cleaning is finished, the device should be dried properly. The interior section of the refrigerator must be free
of water and humidity.
• If the device is to be taken out of operation for a longer period, the inner and outer containers should be cleaned
and the lid should be left open a small gap, to avoid unpleasant smells.
Due to the humidity of the ambient air, a layer of ice will form gradually on the evaporator. If the ice layer is thicker than
1 cm, the cooling capacity of the device will be impaired. In such a case the device must be defrosted.
• Remove the vaccines, Icepacks and isolation inserts. Store them in another pre-cooled refrigerator.
• Switch off the device - Turn the thermostat knob to position "0" and unplug the unit.
• Open the lid and wait until the ice has completely melted. D
KNIFE OR ANY OTHER TOOL
• Open the drainage plug at the bottom of the inner cabinet to let the water drain off.
• After defrosting the interior of the device must be completely and properly cleaned and dried. D
TING DEVICES TO DRY THE DEVICE
• Open the lid of the device just as often and just as long as absolutely necessary, in order to prevent the unit from
humidity penetrating into the interior.
I
CEPACK
X
M A
D
.
.
F
REEZING
C
LEANING
EFROSTING
O NOT MAKE ATTEMPTS TO REMOVE THE ICE LAYER USING A
- 8 -
-
O NOT USE ANY HEA
Werbung
Inhaltsverzeichnis
