Air Filter; Continuous Operation - CO/Tech MDDE-10DEN3-QA3 Bedienungsanleitung

Automatic defrost feature
The dehumidifier is equipped with an automatic defrost feature. Frost can build up
on some components inside the dehumidifier under certain conditions. The defrost
feature removes this frost. No settings can or need to be made for this feature.

Air filter

Removal
1. Grip the water reservoir on both sides
and pull it forwards. See above.
2. Grip the filters (one on each side) and
pull them straight down.
Cleaning
1. Wash the filter carefully in warm water, use a mild detergent if necessary.
Note: Do not wash the air filter in a dishwasher.
2. Rinse the filter in clean water and let it dry before reinserting it.
Fitting
1. Refit the air filters by pushing them up into place.
2. Refit the water reservoir.

Continuous operation

When the dehumidifier is used in an environment with high humidity, the water reservoir
will need emptying often. In such circumstances, it could be more practical to run
the dehumidifier continuously.
1. Remove the rubber plug covering the drain hose connection (8).
2. Connect a suitable drain hose (sold separately) having a bore of 15 mm.
3. Make sure that the drain hose is secure and tight to prevent leakage.
4. The other end of the drain hose should be inserted into a drain which is lower than
the drain hose connection on the dehumidifier.
7