CO/Tech MDDE-10DEN3-QA3 Bedienungsanleitung Seite 6

Instructions for use
Note:
• Make sure that the rubber plug in the drain hose hole is securely in place before
turning the dehumidifier on if it is not to be used for continuous dehumidification.
• The dehumidifier works best at normal room temperature, its efficiency is reduced
if the ambient temperature falls to below 15 ºC.
• Let the dehumidifier operate continuously for 24 hours the first time it used.
See the Continuous operation section.
• If the dehumidifier is turned off and then turned back on again immediately,
it will take approximately 3 minutes to reach full power.
• Never use the dehumidifier without the air filter in place.
Switching the dehumidifier on/off
1. Read all the instructions in the Safety and Placement sections above.
2. Connect the mains lead to a wall socket with the specifications listed in in part 1 of
the Safety section.
3. Switch the thermostat on by pressing [
4. Switch the thermostat off by pressing [
Automatic shut-off
When the water reservoir is full the dehumidifier shuts off automatically and the LED
indicator (9) on the control panel lights.
Emptying the water reservoir
1. Unplug the mains lead from
the wall socket.
2. Grip the water reservoir on both
sides and pull it forwards.
3. Empty the container and then
fit it back into the dehumidifier.
If the dehumidifier is switched
off automatically it takes a few
minutes for it to start again once
the water reservoir has been
refitted.
].
] again.
6