Disty box 5000 Bedienungsanleitung Seite 36

14 2 Registration / programming
Function
Connection of calls
Internal/external call connection. A digit must be dialled to distinguish
whether a call is to be connected within the base station or externally.
This setting is not recommended if parameter 42 is set to 0.
Internal call connection. An internal connection is prepared immedia-
tely on lifting the handset. Only other cordless units on this base stati-
on can be called; no exchange calls are possible. When connecting
an entrance intercom, this can be used to prevent the exchange line
being seized.
External call connection. An external connection is prepared immedia-
tely on lifting the handset. By dialling the relevant code, internal cord-
less units on this base station can also be called.
Factory setting: 2
Flash function
The flash key detection function (R key) of the distybox can be set to
the flash time of your connected device. (Please refer to the operating
manual for your device for this information.) For example, if the flash
time of your device is 100 ms, this corresponds to the setting "10".
The factory setting is 23, which corresponds to 230 ms.
Group ring
The distybox does respond calls from the base sent as "group ring"
calls.
The distybox does not respond calls from the base sent as "group
ring" calls.
Factory setting: 0
Parameter Other input
code
71 0 #
71 1 #
71 2 #
72 Setting #
73 0 #
73 1 #