Disty box 5000 Bedienungsanleitung Seite 31

2
NOTE
Registration / programming
Function
enter the new PIN twice and confirm this by pressing
is confirmed by the positive acknowledgement tone.
Programming mode can then only be accessed again by entering the
new PIN once more.
If you forget the PIN, the distybox can only be reset by the Customer
Service department.
Factory setting: 0 0 0 0
Distance (distybox 5000 only)
Valid entries are 0 - 79.
The setting can be determined using the following mathematical for-
mula:
Distance value = distance [in m] divided by 130
Example: 2,300 m ÷ 130 m = 17.69 -> distance value = 18
This may vary depending on the base station being used. Adjust the
distance value in increments of two, e.g. the distance value for DeTe-
We's OpenCom system is +8.
Factory setting: 0
Connection to an ISDN/
analogue line
This setting has to be used if your base station is connected to an
ISDN phone line. Send Keypad Information, while connection Keypad
information will be suppressed, so it is possible to transmit DTMF sig-
nals.
Suppress Keypad Information: This setting has to be used if your base
station is connected to an analogue phone line.
Parameter Other input
code
. The change
#
3 Distance value #
40 0 #
40 1 #
9