Disty box 5000 Bedienungsanleitung Seite 34

12
Function
Block dialing off
This standard mode transmits the dialed number digit by digit from
connected analogue device to the DECT base.
Block dialing active
In Block dialing mode the dialed number is first stored in distybox
300/5000. After dialing an additional # the dialed number will be
transmitted in one block to the DECT base. This enables usage on ba-
se stations which expect block dialing mode.(e.g. Gigaset C590)
For this function please activate parameters as shown below:
Parameter 49 = 1
Parameter 42 = 1
Parameter 71 = 0
In Block dialing mode the dialed number is first stored in distybox
300/5000. 5 seconds after dialing the last digit the dialed number will
be automatically transmitted in one block to the DECT base. This en-
ables usage on base stations which expect block dialing mode.(e.g.
Gigaset C590)
For this function please activate parameters as shown below:
Parameter 49 = 2
Parameter 42 = 1
Parameter 71 = 0
In Block dialing mode the dialed number is first stored in distybox
300/5000. After dialing an additional # or automatically 5 seconds af-
ter dialing the last digit, the dialed number will be transmitted in one
block to the DECT base. This enables usage on base stations which
expect block dialing mode.(e.g. Gigaset C590)
For this function please activate parameters as shown below:
Parameter 49 = 3
Parameter 42 = 1
Parameter 71 = 0
Factory setting: 0
Parameter Other input
code
49 0 #
49 1 #
49 2 #
49 3 #