Setting Parameters In Programming Mode - Disty Box 5000 Bedienungsanleitung

8
NOTE
2 Registration / programming

2.2.2 Setting parameters in programming mode

Not all the features offered by the distybox are supported by every
DECT/GAP base station. Refer to the operating manual for your base sta-
tion to clarify which features you can use.
Programming mode needs to be activated before this parameter can be
set. The function-programming process is concluded by entering
confirmed by the positive acknowledgement tone. You will then hear the
special dialling tone once more, which means that you can continue pro-
gramming other functions. With the exception of programming points 90,
91 and 99, the change is effective without having to restart the distybox.
If an invalid value is entered during programming, a negative acknowled-
gement tone is sounded, the procedure is cancelled and you will hear the
special dialling tone once more.
If during programming no input is made for one minute, the procedure is
cancelled and you will hear the special dialling tone again.
Programming mode can be exited at any time by replacing the handset;
the distybox will then be returned to normal mode.
Function
Manual registration of
the distybox
The base station PIN needs to be entered to register the distybox.
A PIN with 0 to 8 digits will be accepted by the distybox. After entering
you will hear the positive acknowledge tone. Leave the handset off
#
hook and wait until you hear again the special dial tone, which means that
the registration is completed. If the registration process has not been
completed successfully within approx. 3 minutes, crosscheck the settings
of the base station and try again.
Access to programming mode can be protected using the four-digit PIN.
Changing the PIN
Access to programming mode can be protected using the four-digit PIN.
The PIN only needs to be entered if a new PIN has been set beforehand
in programming mode. To change the PIN, activate programming mode,
Parameter Other input
code
1 Base PIN #
2 new PIN new PIN #
and
#