AEG Beat 15 Bedienungsanleitung Seite 28

28
Press (Left soft key) to show "NEW PIN?----", and enter your new
4-digit system PIN.
Press (Left soft key) to show "CONFIRM?----", and enter your new
4-digit system PIN again.
Note:
If the new PIN entered in Step 6 is not the same as the new system
PIN entered in Step 5, you must enter the new system PIN again from
Step 5.
Press (Left soft key) to confirm.
10.4.6 Call share
When the Call Share is set "ON", the handset and base can interrupt
an existing external call and start a conference call simply by pressing
or .
Press (Left soft key) and
Press (Left soft key) and
Press (Left soft key) and
Press (Left soft key) to confirm.
10.5 Registration
Important:
When you purchase your phone system, all handsets are already
registered to your base, so you do not need to register them.
Handset registration is only necessary when you buy extra handsets or
if a handset has become faulty.
You can register up to five handsets to the base, but each handset can
only be registered to one base.
To register a new handset to your base:
Using the handset:
Press (Left soft key) and
"REGISTRATION".
Press (Left soft key) to show "PIN?----".
Enter the 4-digit system PIN (default 0000).
Press (Left soft key) and the display will flash "PLEASE WAIT".
Using the base:
Press and hold
base beeps to indicate it is in registration mode. After a short delay,
/
/
/
on the base station for about five seconds, until the
to select "BS SETTINGS".
to select "CALL SHARE".
to select "ON" or "OFF"
/ on the handset to select