Closing The Door - Electrolux TG092 Benutzerinformation

Problem
The compressor does not
start immediately after
pressing the FastFreeze,
or after changing the tem‐
perature.
Temperature cannot be
set.
Door is misaligned or inter‐
feres with ventilation grill.
The temperature in the ap‐
pliance is too low/too high.
Door does not open easily. You attempted to re-open
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

8.2 Closing the door

1. Clean the door gaskets.
Possible cause
This is normal, no error
has occurred.
The FastFreeze function is
switched on.
The appliance is not level‐
led.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been opened
often.
The FastFreeze function is
switched on.
There is no cold air circula‐
tion in the appliance.
the door immediately after
closing.
2. If necessary, adjust the door. Refer
3. If necessary, replace the defective
Solution
The compressor starts af‐
ter a period of time.
Switch off FastFreeze
manually, or wait until the
function resets automati‐
cally to set the tempera‐
ture. Refer to "FastFreeze
function"
Refer to "Levelling".
Set a higher/lower temper‐
ature.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if nec‐
essary.
Refer to "FastFreeze func‐
tion".
Make sure that there is
cold air circulation in the
appliance.
Wait a few seconds be‐
tween closing and re-open‐
ing of the door.
to "Installation".
door gaskets. Contact the Authorised
Service Centre.
ENGLISH 63