Phocos CMLNL Bedienungsanleitung Seite 32

The controller is preset to Mode 1 from the factory. Changing the
mode setting is described below.
In case of doubts which mode to choose, consult your dealer
because this has to be evaluated depending on the battery used.
Settings
The controller can be configured for special operation. For this
purpose, open the cover of the controller by removing the screws
on the back side.
WARNING: The controller should not be opened while connected
and in operation!
When the controller is opened, there are 2 jumpers on the electronic
board:
For changing, put the
jumper either on both
contact pins or only on one
contact pin:
29
Closed jumper
Open jumper