Hama 00012086 Bedienungsanleitung Seite 5

Code-identification
The code identification offers you the
possibility, already to determine entered
codes that are stored in the remote control.
So go ahead.
• Hold the key setup (4) pressed for approx.
3 seconds until the red LED (1) lights up
permanently.
• Press the source key (3) (TV, DVD, STB)
shortly.
• You press the key setup (4) shortly, the
red LED (1) goes out shortly during the
keystroke.
• In order to find the first number, you press
the numeric keys (8) from 0 to 9.
• If the red LED (1) goes out shortly, it is the
first
stored number.
• In order to find the second number, you
press in turn the numeric keys (8) from 0 to
9 until the red LED (1) goes out.
• Repeat the process for the third and the
fourth number.
• The red LED (1) goes out as soon as the key
was pressed for the fourth number.
• The code-identification is now finished.
8
Normal use
After you have carried out the programming
of your remote control for yours audio/video
device, the remote control works in the most
common primary functions as the original
remote control of the respective device.
Focus your remote control on the wanted
device and press the corresponding source
key. The red LED will light up shortly.
They activate the functions now through
pressing of the corresponding function key of
your universal remote control.
At every keystroke the red LED lights up
shortly.
Possibly every function of your original
remote control is not directly available on the
universal remote control.
In particular near newer devices it is possible
that the functions are first of all put aside or
not at all available among other keys than
expected.
With the AV Taste you choose usually the
AV input of the TV set for e.g. the STB
receiver or the video recorder.
Special functions
„electronic program"
The key EPG (12) corresponds to the function
„Electronic Program Guide" and has different
functions, depending on which device this
is used.
At STB - or VCR - codes keep you up the key
a programming carry out, provided that
your video recorder about a SHOWVIEW
- function.
Debugging
The remote control does not function:
• Check the batteries of the remote control
are correctly inserted and the polarity +/- is
right
• Check your devices are correctly
connected and turned on.
• If the batteries are too weak, you exchange
these through new.
• Several device codes are performed under
the brand name of my device. How do I
determine the correct device code?
• In order to determine the correct device
code for your device, you try out the codes
after each other until most functions of the
device function properly.
The devices react only to some commands of
the remote control:
• You test further codes, to which according
to devices by the commands react.
• If the manual code input and the automatic
code search do not lead to the success,
it can happen in special individual cases
that the device is not compatible to your
universal remote control.
9