Axis Q6042-E Installationshandbuch Seite 17

AXIS Q60 Series
1
Network connector – RJ45 Push-pull Connector (IP66)
2
Network connector and network connector shield
3
Ground screw T20
4
Washer
5
Cable shoe
6. Attach the grounding wire to the cable shoe using cable shoe pliers.
7. Put the cable shoe and washer back in their original positions and tighten the screw
(torque 0.5 Nm). Make sure the cable shoe is in contact with the grounding surface.
8. Connect the network cable to the camera.
NOTICE NOTICE NOTICE
Be careful not to damage the network cable when connecting it.
9. Slide the unit holders on the network camera into the slots in the mounting bracket and
rotate the camera unit.
10. Secure the network camera to the mounting bracket by tightening the screws.
11. Install the supplied midspan. See page 18.
5
17
1