Oscillation; Temperature - Fakir HT 1600 Motion Bedienungsanleitung

Base

Oscillation

Louver
Oscillation

Temperature

HT 1600 MOTION
2. Use the temperature setting button to set the required
temperature.
3. If the ambient temperature is below the set temperature,
the heater will operate in HIGH (Hi) mode.
4. Once the thermostat reaches the set temperature, the
heater will switch to LOW mode to save energy. The
heater will turn on and off in LOW mode to maintain the
set temperature.
5. This is all handled automatically thanks to the Lasko
Save-Smart® Technology.
6. To disable the Save-Smart® function and force the unit
to operate in high/low mode, press the Save-Smart®
button again.
NOTE!
If the Save-Smart Eco setting button is not pressed, the
heater will permanently run in MAX mode. Save-smart
function will be enabled and switch to eco mode if the
Save-smart eco button is pressed.
Press the Base Oscillation Button to start and stop the
oscillation function when the heater is turned on. The
oscillation function may be used in any heat and/or timer
mode.
Press the Louver Oscillation Button to start and stop the
oscillation function when the heater is turned on. The
oscillation function may be used in any heat and/or timer
mode.
Use the temperature setting button to set the heater to the
desired temperature when it is turned on.
NOTE!
The light above the chosen temperature will keep
flashing until the room temperature reaches the set
value.
27
GB