Optimum Time OS 1-SERIES Bedienungsanleitung Seite 3

OS Series 1.qxd 11/11/05
10.
Press the 'PROG' button to set the date.
11. At this point choose between English calendar (date then month) or the American calendar (month then
date). The default setting is English. To change to American press the 'START/STOP' button. To revert to
English press 'START/STOP' again.
12.
You can now confirm the time and date settings by pressing 'CLEAR' or go back to the setting of the hours
by pressing 'MODE'. As soon as you are happy with your settings press 'CLEAR' to confirm. The display
will also stop flashing.
TO ACCESS THE CALENDAR FROM THE TIME MODE
1.
Press 'MODE'. The calendar will be displayed for 5 seconds and then revert to time. If you press 'MODE'
again within those 5 seconds you will access the alarm mode.
TO SET THE ALARM
1.
Press 'MODE' to access the alarm. This comes after Time and Calendar but before Timer. i.e. the sequence
is Time, Calendar, Alarm and then Timer.
2.
Once in alarm the alarm icon AL comes on. Once in alarm
mode you can switch the alarm on or off by pressing 'START/STOP'. The icon for alarm on
displayed next to the letters AL. (When you leave the alarm mode the AL icon goes out, but if the alarm is
on the alarm on icon will stay on whatever the mode.)
3. To set the alarm press 'CLEAR' and hold it down for 2 seconds until a beep is heard and the hours flash.
4.
Set the hours by pressing 'PROG'. The alarm has to operate in the same 12/24 hour mode you have
chosen for the time. Be careful to set the correct time for the alarm.
5.
Press 'MODE' to confirm the hours and start the minutes flashing.
I n s t r u c t i o n s
4
6:05 PM Page 4
will be
E N G L I S H
6.
Press 'PROG' to change the minutes.
7. Press 'CLEAR' to confirm the setting or press 'MODE' to re-access the hour setting.
COUNTUP OPTION
1.
Once in the timer mode press the 'CLEAR' button. This will only function if the timer is not running. (If the
timer is running, press 'STOP' first and then press 'CLEAR'). The display will now show 0:00.
2.
Press 'START' and the timer will count up from zero in minutes and seconds up to a maximum of 59 mins
and 59 seconds. The display will also show an arrow icon
3. During count-up the timer can be stopped and restarted as many time as required.
NOTE: The count-up timer will only work if the countdown timer is in countdown and up mode and not
countdown repeat. (see next section)
PROGRAMMED COUNTDOWN MODE
There are 4 different pre-programmed timing sequences They are: 5,4,1,0 minutes, 5 minute periods, 3 minute
periods and a 1 minute period, plus two types of countdown. They are countdown and up or countdown repeat.
It is possible to choose multiples of these periods (e.g. 2 x 5 minutes = 10 minutes) in countdown and up plus
the 1 minute setting of countdown repeat. Multiples of 5,4,1,0, 5 minutes and 3 minutes are not available in
countdown repeat. Each pre-programmed period has a short alarm sound every minute, and for the last minute
of countdown an alarm at 50, 40, 30 & 20 seconds, and also an alarm for each of the last 15 seconds.
E N G L I S H
to denote count-up.
I n s t r u c t i o n s
5