Abicor Binzel PSB 31 Betriebsanleitung Seite 31

PSB
AUT PSB 60
6
1 Handle tube AUT
2 Electrode
Fig. 3 AUT PSB 60 and AUT PSB 121
5.5 Connecting the plasma cutting torch
5
3 Plasma nozzle ø1.0; 1.3; 1.5; 1.8; 2.0
4 Spring receiver
NOTICE
• Make sure that the connections are properly assigned and tightened.
• Since the plasma nozzle cannot be protected against direct contact for
technical reasons, the plasma cutting power source must fulfil the
requirements of EN 60974-7, point 7.4.2.
• The plasma cutting torch in connection with the plasma power source
must conform to EN 60974-10.
• The plasma power source must also conform to EN 60974-1.
• The plasma power source and cutting torch must have the same type of
ignition (contact or HF) and the same output power (rated current and
corresponding duty cycle).
 Tab. 3 on page EN-5
1
5 Electrode wrench
6 General purpose wrench
5 Putting into operation
AUT PSB 121
2
3
4
EN - 13